My remaining task was to find a source The Lost Ways of ignition. It only took a moment to equate a source of ignition for my fire to the source of ignition in my automobile, and the idea of a spark from my car battery came to mind. Now the only challenge was to get the spark from the battery to the location where I wanted to start the fire. To do that, I used jumper cables and clasped long nails in the jaws of the jumper cables so I would have small surface areas to strike against one another to create a healthy spark from the battery.Being mindful of the explosive nature of gasoline, I first obtained a steel bung hole screw plug, the kind that often comes with a 55 gallon drum. This would be used to limit the amount of fuel and contain the initial flame to a very small area inside the steel plug. Dispersing the fuel over a larger surface area was an invitation to an explosion, so I kept it well confined in the steel plug and only used about a tablespoon full.Next, I gathered tinder in the form of twigs, and kindling in the form of small branches. Once the fire started, I wanted to quickly get twigs and branches on fire to build on my initial success. After all, the small amount of gasoline would only burn for about one minute.Then I pulled the car up near where I wanted the fire and filled the steel bung plug with a small amount of gasoline and then huddled some tinder around it. The gasoline container was then moved upwind and far away so there was no chance of ignition. I hooked up the jumper cables and nails, and set one nail in the small puddle of fuel and struck the other nail against it quickly to create a generous spark. https://discountdevotee.com/the-lost-ways-review//